Emission factors for high-emitting vehicles based on on-road measurements of individual vehicle exhaust with a mobile measurement platform

Fuel-based emission factors for 143 light-duty gasoline vehicles (LDGVs) and 93 heavy-duty diesel trucks (HDDTs) were measured in Wilmington, CA using a zero-emission mobile measurement platform (MMP). The frequency distributions of emission factors of carbon monoxide (CO), nitrogen oxides (NO(x)), and particle mass with aerodynamic diameter below 2.5 microm (PM2.5) varied widely, whereas the average of the individual vehicle emission factors were comparable to those reported in previous tunnel and remote sensing studies as well as the predictions by Emission Factors (EMFAC) 2007 mobile source emission model for Los Angeles County. Variation in emissions due to different driving modes (idle, low- and high-speed acceleration, low- and high-speed cruise) was found to be relatively small in comparison to intervehicle variability and did not appear to interfere with the identification of high emitters, defined as the vehicles whose emissions were more than 5 times the fleet-average values. Using this definition, approximately 5% of the LDGVs and HDDTs measured were high emitters. Among the 143 LDGVs, the average emission factors of NO(x), black carbon (BC), PM2.5, and ultrafine particle (UFP) would be reduced by 34%, 39%, 44%, and 31%, respectively, by removing the highest 5% of emitting vehicles, whereas CO emission factor would be reduced by 50%. The emission distributions of the 93 HDDTs measured were even more skewed: approximately half of the NO(x) and CO fleet-average emission factors and more than 60% of PM2.5, UFP, and BC fleet-average emission factors would be reduced by eliminating the highest-emitting 5% HDDTs. Furthermore, high emissions of BC, PM2.5, and NO(x) tended to cluster among the same vehicles.     

PCDDs, PCDFs, and PCBs concentrations in breast milk from two areas in Korea: body burden of mothers and implications for feeding infants

We determined breast milk concentration of polychlorinated dibenzo-p-dioxins (PCDDs)/polychlorinated dibenzofurans (PCDFs) and polychlorinated biphenyls (PCBs) in 24 mothers living in Korea, and assessed the maternal body burden based on PCDDs/PCDFs and PCBs concentrations in breast milk and an infant intake rate through breast-feeding based on their concentration in breast milk. PCDDs/PCDFs and PCBs levels in breast milk from primipara mothers were found to be higher than those from multipara mothers. For total PCDDs/PCDFs TEQ level, 2,3,4,7,8-PeCDD was the predominant congener, and the proportion of 2,3,7,8-TCDD was less than 3% of total PCDDs/PCDFs TEQ level. For PCBs TEQ level, PCB-126 was the predominant congener. Maternal body burden levels of PCDDs/PCDFs and PCBs based on their concentrations in breast milk were 268-622 TEQ ng. The daily dioxin intakes of mothers were predicted to be 0.78-2.18 TEQ pg/kg/day for PCDDs/PCDFs and 0.34-0.66 TEQ pg/kg/ day for PCBs. For the first year, the body burden of an infant was predicted to be 212 TEQ ng and the daily intake of an infant was predicted to be 85 TEQ pg/kg/day, assuming the mean dioxin-related compounds concentration (27.54 TEQ pg/g fat).     

ESTIMATION OF POTENTIAL REDUCTIONS IN RECREATIONAL BENEFITS DUE TO SEDIMENTATION1

ABSTRACT: A travel cost model is developed to estimate the potential reductions in recreational benefits from sedimentation in Reelfoot Lake in northwestern Tennessee. In addition to the consumer surplus estimates generated by the model, three other aspects of the study were significant. First, the study applied a relatively untested methodology for deriving the opportunity cost of travel time. The study resulted in a value that is less than one-half of the Water Resource Council's “one-third of the wage rate” rule-of-thumb. Second, water quality perceptions were unsuccessfully incorporated into the model as a demand shifter. This raised questions as to the appropriate manner in which perceptions could be included in a travel cost model. Finally, a simple methodology was outlined by which estimates of the recreational value of Reelfoot Lake could be used to suggest how much cost could be justified for soil erosion control on agricultural land surrounding the lake.     

Intentionally building relationships between participatory online groups and formal organisations for effective emergency response

Advances in information and communication technologies enable the public to contribute to emergency response. For instance, reporting systems set up during recent disasters allowed affected people to submit testimonies about conditions on the ground. In addition, the public has analysed data and helped to mobilise and deliver relief resources. To plan intentionally for an integrative emergency response system in the networked age, this research explores two subject areas: (i) the organisational and technical determinants of relationships forged between formal organisations and participatory online groups established by the public; and (ii) the consequences of the outcomes generated by these relationships. Four in‐depth case studies were selected for the analysis, which revealed that resource dependence, shared understanding, and the use of certain types of information technology influence the formation of such relationships. Furthermore, healthy collaborative relationships increase the chances of desirable results, including inter‐organisational alignment and minimal long‐term harm owing to a disaster.     

雨雪冰冻灾害后粤北森林各林型凋落物动态

为了考察中国亚热带不同森林类型对雨雪冰冻灾害的响应模式,以粤北天井山3种代表性的林型—针叶林、阔叶林和混交林为对象,于不同森林类型中比较受损森林与未受损森林在凋落物年产量、成分及月际动态方面的差异,从而在凋落物水平上反映不同森林类型在雨雪冰冻灾害后的早期恢复力。研究结果表明,灾后针叶林、阔叶林和混交林的年凋落量分别为0.52、3.21、1.37 t.hm-2,比未受损的同种森林类型年凋落量显著减少,减少程度分别为87.89%、53.46%、76.78%。由此可以看出阔叶林的植被恢复情况最好,说明在凋落物水平上,其灾后恢复的早期阶段恢复力最强。在凋落物成分方面,灾后各森林类型叶凋落物所占比例显著增加,枝凋落物所占比例则显著减少。受损针叶林和阔叶林的凋落物月动态与未受损森林基本一致,但其波动幅度较小;在混交林中,受损和未受损森林其凋落量的季节动态模式则表现出不一致性且为不规则型。根据研究结果,建议在亚热带地区优先考虑种植阔叶林以促进受损森林在类似雨雪冰冻灾害的极端天气后的恢复。     

Inhibition of pyrite oxidation by surface coating: a long-term field study

Pyrite and other iron sulfides are readily oxidized by dissolved oxygen in aqueous phase, producing acidity and Fe²⁺, which causes significant environmental problems. Applications of surface coating agents (Na₂SiO₃ and KH₂PO₄) were conducted at Boeun (Chungbuk, South Korea) outcrop site, and their efficiencies to inhibit the oxidation of sulfide minerals were monitored for a long-term period (449 days). The rock sample showed positive Net Acid Production Potential (NAPP = 20.23) and low Net Acid Generation pH (NAGpH = 2.42) values, suggesting that the rock sample was categorized in the potential acid-forming group. For the monitored time period (449 days), field study results showed that the application of Na₂SiO₃ effectively inhibited the pyrite oxidation as compared to KH₂PO₄. Na₂SiO₃ as a surface coating agent maintained pH 5–6 and reduced oxidation of pyrite surface up to 99.95 and 97.70 % indicated by Fe²⁺ and SO₄ ^2? release, respectively. The scanning electron microscope and energy-dispersive X-ray spectrometer analysis indicated that the morphology of rock surface was completely changed attributable to formation of iron silicate coating. The experimental results suggested that the treatment with Na₂SiO₃ was highly effective and it might be applicable on field for inhibition of iron sulfide oxidation.     

Differences in Eye and Hand Movements of Novice and Experienced Press Operators

Presses are very widely used in industrial and commercial companies and are often the source of serious accidents occurring during operation. Most of the accidents are due to inadequate training of novice operators. Continuous recordings of eye and hand movements of five novice operators and five experienced operators in press operation were made. Significant difference between novice and experienced operators was observed in eye fixation time, eye movement patterns, hand dwell time, and eye-hand coordination. Also, differences were observed in spatial distribution of eye fixations during the die-closing portion of a stroke. There were no significant differences between novice and experienced operators in the eye and the hand movement time. The results could be used as basic data to establish a guide determining the method and training period to train novice operators.     

Screening and prioritizing the precursors of improvised explosive devices from commodity chemicals being controlled under Korean regulations

Improvised explosive devices (IEDs) have become an alternative method for terrorists or criminals who face difficulties in obtaining traditional explosives as threatening tools. The ease of obtaining precursor materials from commodity chemicals in the free market and the ease of generating bombs through the hands of novices have created problems. Controlling the potential precursors to defeat illegal acquisition is not trivial due to their widespread use as common merchandise among chemical industries and consumers. However, efforts to identify the potential precursors may be the first step for devising appropriate control measures. In this study, we proposed a systematic screening method for identifying potential IED precursors (IEDPs) from commodity chemicals, which are regulated by Korean controls. We identified 25 potential IEDPs from 3980 candidate chemicals that can be diverted into IEDs or homemade bombs but are not likely to be solely used as an IED. We also developed a methodology of prioritizing the potential precursor chemicals to assess the urgency of controls using a scoring system with four criteria: previous listing as an official precursor; past record of being encountered in criminal use; volume of commercial circulation, which denotes the probability of exposure to individuals; and the degree of regulatory counter-measures against illegal acquisitions that are currently effective in Korea.     

Particle Surface Hydrophobicity and the Dechlorination of Chloro-Compounds by Iron Sulfides

Halogenated aliphatic compounds (HACs) can be reduced by iron sulfides in aqueous systems. Generally, the thermodynamics and kinetics of dehalogenation reactions are controlled by the mineralogical and particle surface characteristics of the iron sulfide, the composition of the HAC and reaction conditions such as component concentrations, pH and Eh. In this theoretical and experimental investigation of CCl₄ and C₂Cl₆ reduction by FeS and FeS₂, the roles of hydrophobic and hydrophilic sites on the iron sulfides were analyzed. Experimental data obtained through zeta potential measurements, were used along with the Gouy-Chapman model and the simple two-layer surface complexation model to relate iron sulfide surface hydroxyl densities to the degree of HAC dehalogenation. The surface hydroxyl site densities of FeS and FeS₂ were found to be 0.11 sites/nm² and 0.21 sites/nm², respectively. During the dehalogenation reaction process, CCl₄ was found to decrease to its first intermediate product CHCl₃ within the first 20 hours followed by a slower process of conversion to CH₂Cl₂. The results also show that FeS is less hydrated (more hydrophobic) than FeS₂. For CCl₄ and C₂Cl₆, FeS is a better dehalogenator than FeS₂. These results imply that particle surface hydrophobicity is a critical factor in surface-mediated dehalogenation of chlorinated compounds.     

Improvement of nuclide leaching resistance of paraffin waste form with low density polyethylene

Low-level liquid borate wastes have been immobilized with paraffin wax using a concentrate waste drying system (CWDS) in Korean nuclear power plants. The possibility for improving chemical durability of paraffin waste form was suggested in this study. A small amount of low density polyethylene (LDPE) was added to increase the leaching resistance of the existing paraffin waste form. The influence of LDPE on the leaching behavior of waste form was investigated by performing leaching test according to ANSI/ANS-16.1 procedure during 325 days. It was observed that the leaching of nuclides immobilized within paraffin waste form made a marked reduction although little content of LDPE was added to waste form. The acceptance criteria of paraffin waste form associated with leachability index (LI) and compressive strength after the leaching test were fully satisfied with the help of LDPE.